Landracing Forum

Loring Timing Association (Maine) => Loring (AFB) land speed venue => Topic started by: JalopyGene on January 18, 2025, 10:23:04 AM

Title: 2025 Maine Event
Post by: JalopyGene on January 18, 2025, 10:23:04 AM
Just wanted to help spread the word and post up the dates for The 2025 Maine event, July 16-19 and a tentative date of Sept 3-6 for the Harvest Event if there are enough registrants.  I'm hoping to have my roadster ready for the July event!
Title: Re: 2025 Maine Event
Post by: Jack Gifford on January 18, 2025, 09:23:51 PM
Thanks. I can hope(?) to get the two cylinder lakester to the July event. Rings were just shipped, I'll gap them soon and can then begin engine assembly.
Title: Re: 2025 Maine Event
Post by: Frank06 on January 19, 2025, 02:05:43 PM
Thanks for starting this, it's always a great event!  I'll be there volunteering - also adding about 100 hp to my electric motorcycle.
Title: Re: 2025 Maine Event
Post by: greencar on January 21, 2025, 04:50:37 PM
The Harvest event is my favorite, hope enough racers register to make it happen
I am volunteering to help set up a day or two before the start of the events.
Looking foward to seeing everyone
All the best
Ed
Title: Re: 2025 Maine Event
Post by: Blown Income on February 04, 2025, 09:10:37 AM
Planning to be at both events, fingers crossed we get enough entrants for the Harvest Event to take place.
Title: Re: 2025 Maine Event
Post by: gofast on May 14, 2025, 06:13:33 PM
The Flying Seven team will be there with the new GMC truck. Can't wait!
Title: Re: 2025 Maine Event
Post by: Jack Gifford on May 14, 2025, 08:52:55 PM
I can't remember the year of your GMC. Just wondering if I should bring my '59 GMC for a "face off" with you?
Title: Re: 2025 Maine Event
Post by: gofast on May 15, 2025, 02:58:51 AM
Mines a 46 with a 302 GMC inline. Lets go line them up!
Title: Re: 2025 Maine Event
Post by: BlueBomber on July 06, 2025, 08:39:27 AM
Whoop-whoop!  I can't wait!  Putting the driveshaft loop and safety wire on on my '53 Studebaker Starliner today....