I NEED A H&C 6355 CAM, SOMETIMES CALLED A 408

Started by 38flattie, June 04, 2013, 05:56:16 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

38flattie

June 04, 2013, 05:56:16 PM
I have a special project, and want to copy a H&C 6355 cam, for a FED/gasser project.

Does anyone out there have one, or know the whereabouts of one?

Thanks in advance!


With sufficient thrust, pigs fly just fine. However, this is not necessarily a good idea. It is hard to be sure where they are going to land, and it could be dangerous sitting under them as they fly overhead. -- RFC 1925

You can't make a race horse out of a pig. But if you work hard enough at it you can make a mighty fast pig. - Bob Akin

http://www.flatcadracing.org/
http://youtu.be/89rVb497_4c

RichFox

#1
June 04, 2013, 06:12:35 PM
Did you ask Dema?

38flattie

#2
June 05, 2013, 08:44:55 AM
Yes I did, but he doesn't know if he has it. He's going to look and see.

I want to pattern off of an original cam, as a lot of cam grinders seem to make small 'improvements' over competitor grinds!
With sufficient thrust, pigs fly just fine. However, this is not necessarily a good idea. It is hard to be sure where they are going to land, and it could be dangerous sitting under them as they fly overhead. -- RFC 1925

You can't make a race horse out of a pig. But if you work hard enough at it you can make a mighty fast pig. - Bob Akin

http://www.flatcadracing.org/
http://youtu.be/89rVb497_4c
Print
Go Up Pages1
User actions