1520 cc Flat Six Motor Kit

[TheBaron]

Hi All,,, I have a nice Goldwing flat-six that could make a good motor for a project...It just fits in  "H" class (I think), and these motors are all aluminum torque monsters ( 90hp and 100 ft-lb) that respond well to NOS or other power adders...

I have the motor with Carbs, Wiring harness, Ignition box, starter, alternator, drive shaft, rear diff. exhaust headers, exhaust collector, and this is the SE model that has Reverse....

Been in clean dry storage and spins over easy. 1991 model with 75k miles.... $475 to the LSR community in SOCAL...and I can deliver up 90 miles from me in Costa Mesa

Robert

[RichFox]

Isn't H class 1500cc?

[BHR301]

Class H is 1016cc to 1523cc.

Bill

[RichFox]

Dodge those CCs. I went to some trouble to make my G and F motors come out at 2 and 3 liters. Should have read closer I guess.

[jacksoni]

Well, you have  0.99ci leeway but interestingly the conversion to cc is rounded down and not always consistently the same. Either way, 3cc is not much clearance to legality in H. Better not be any wear/slack in the measurements!