Video from the SW start line!

Started by Seldom Seen Slim, July 17, 2021, 04:32:19 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Seldom Seen Slim

Ron Main set notice that there'll be live video from the start line Sat-Sun-Mon of SpeedWeek.   Yippee for youse guys and me too!
Jon E. Wennerberg
a/k/a Seldom Seen Slim
Skandia, Michigan
(that's way up north)
2 Club member x2
Owner of landracing.com

handyguy

  What is happening on the SHORT course ..   STEVE

Seldom Seen Slim

I don't know any further details.  Sorry... :-(
Jon E. Wennerberg
a/k/a Seldom Seen Slim
Skandia, Michigan
(that's way up north)
2 Club member x2
Owner of landracing.com

sabat

Yay! And there goes my productivity Aug 8-13  :friday

Dodge Brother

This is great news, especially for those of us not allowed in the country  :friday :clap

4bangerbob

Jon

will you be having the internet audio feed again this year? 

Seldom Seen Slim

I sure plan to do so.  I suspect that the stream will be available via many sites and FB page as well as landracing.com.  Bob will be resetting the stuff on the home page tomorrow, and I'm planning on getting the system running once I'm done with toilets next week.  Stay tuned for more! 
Jon E. Wennerberg
a/k/a Seldom Seen Slim
Skandia, Michigan
(that's way up north)
2 Club member x2
Owner of landracing.com

manta22

Thank you, Jon. We appreciate this!
Regards, Neil  Tucson, AZ

sabat

Well, this got my blood pressure up this morning :)

I'm enjoying the SCTA-BNI Instagram page...

https://www.instagram.com/p/CR8GBEvn0Si/

Stainless1

Wow, I saw on another thread that the SD was on a fancy  dyno.... That was a pretty short sweep... I know for a fact that dyno will do a 40 second sweep from 4K - 11K....  Just did one a couple of days ago...
Did I mention that dyno looks just like my Roth IRA   :roll:
Stainless
Red Hat 228.039, 2001, 65ci, Bockscar Lakester #1000 with a little N2O

Stainless1

Stainless
Red Hat 228.039, 2001, 65ci, Bockscar Lakester #1000 with a little N2O

sabat

Drool... what brand of dyno is that? All I know is Dynojet, and I haven?t played much with load control.


Stainless1

My Roth IRA is a Dynomite Axle hub 1000 HP Dyno.  It will run over 1000 HP, but not for long... they make them up to 6000HP absorbers... I figured if I get a motor that makes more than the dyno will handle I'll be going too fast  :?  :roll:
They can be controlled manually or by a laptop... Laptops used around dyno's should have a solid state harddrive. acoustic vibration will freeze the spinning disk type.
Stainless
Red Hat 228.039, 2001, 65ci, Bockscar Lakester #1000 with a little N2O

racergeo

   First off Slim I would like to compliment you on your speaking voice. You are very pleasant to listen too. I have a big favor to ask, as I will be tuned in to your POD Cast.

   Could you give occasional updates. Such as " If you just tuned in here are the cars that have gone to impound so far today"  " the fastest car in the largest class, C/IR is the #62 with a speed of....." "If you just tuned in the #77 J&S racing streamliner drive by Arley Langlo has eclipse the 400mph mark for the first time" "The Speed Demon is in line again after running 480 ealier today, but is looking for more speed" " should be running within an hour" and of course "the #7 C/GL with the exotic 12 cylinder engine just posted a time of...."   Oh, and the occasional lament that Marlo isn't here with the conditions being so good"   SOB :-(    Take some notes and give us some frequent updates. 




            Your Fan  George Johnson

Stan Back

...and mention my name every hour on the hour.  And how much you miss me.  You're getting the big bucks for this, so don't let us down.
Past (Only) Member of the San Berdoo Roadsters -- "California's Most-Exclusive Roadster Club"