SCTA approved flywheel hoop ?

Started by Jeff Brock, July 26, 2009, 07:00:44 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

Jeff Brock

July 26, 2009, 07:00:44 AM Last Edit: July 27, 2009, 09:16:19 PM by Jeff Brock
sharing the "final strokes" of my 320 Buick build with Mr. Fox in an email last night , I noted that I used a Ansen , cast steel bell .
He noted it's NOT SCTA approved .

... I read that a"SCTA 1/4" thick flywheel shield providing 360* coverage" .
I can fab a hoop to go around this Ansen .
Can / will it be approved "on site" / at tech inspection time ?
I'm thinking 6" wide?

Jeff Brock
BROCK ART SPEED

SPARKY

#1
July 26, 2009, 07:51:31 AM
an open to the rear "Band" will not pass--- you will have to "close it" to the tranny so that the schrapnel can't get out.
Miss LIBERTY,  changing T.K.I.  to noise, dust, rust, BLUE HATS & hopefully not scrap!!

"Security is mostly a superstition. It does not exist in nature, nor do the children of men as a whole experience it. Avoiding danger is no safer in the long run than outright exposure. Life is either a daring adventure or nothing."   Helen Keller

We are going to explore the racing N words NITROUS & NITRO!

RichFox

#2
July 26, 2009, 09:02:45 AM
Can't get out the top. Although I have seen some that do not extend down to the transmission case. As you saw on the picture I sent mine is 6 inches wide in the plane of the flywheel and covers the top half down to the transmission case.
Print
Go Up Pages1
User actions