Breaking Wind

[lsrjunkie]

Looking good Joe! Nice work!

[skywalker18]

I love the stance of the car!!  You guys have top notch build quality, and I can't wait to watch the build progress.

[javajoe79]

Thanks. It's really looking like a car now.

[javajoe79]

 More tube work



This shot shows all the tubes that intersect above the drivers head. I will be adding more triangulation all over the place too.

[DND]

Hi Joe

Are you planning on running this year or just when it gets done, great job with your metal fab work

G Don

[javajoe79]

Hi Joe

Are you planning on running this year or just when it gets done, great job with your metal fab work

G Don

Next year I am sure. Shakedown at Ohio then speedweek hopefully. Thanks

[tauruck]

Joe, it's looking better and better.

Thanks for the photos.

[javajoe79]

Thanks man

[javajoe79]

Uprights are here finally!!  Time to build front suspension.

[gnx7]

Incredible build guys!  Chris is one hell of a fabricator!

Darryl-  what block, crank/rods, heads/intake on the 555ci setup?

[tauruck]

Standard stuff for Coffey fabrication IMO.

Great looking components.

[manta22]

Joe;

What calipers are you fitting on these nice looking uprights?

Regards, Neil  Tucson, AZ

[javajoe79]

Joe;

What calipers are you fitting on these nice looking uprights?

Regards, Neil  Tucson, AZ

Not sure yet. We have a set of fairly big wilwood four piston calipers for the rear. Probably something similar up front.

[manta22]

Those should stop you nicely if your 'chute doesn't open! 

Regards, Neil  Tucson, AZ

[javajoe79]

A little progress on bridging the dash area to the windshield and a few more bars in the cage. Waiting on parts to fab the front suspension.