Springfield Flyer.

wobblywalrus · July 26, 2016, 08:51:51 PM

Was that near your house? That is scary.

tauruck · July 27, 2016, 12:46:31 AM

That little puppy ripped a shopping mall about 10 miles away to shreds.
Looks like the government is allowing more American imports.

I've never seen wind like that in my life but if I was still 12 my kite would have been UP!!!!!!!.

floydjer · July 27, 2016, 06:05:39 AM

Yeah,....When I was 12 my kite was up all the time.....................

Ron Gibson · July 27, 2016, 06:24:26 AM

New name?

?

Ron

Stainless1 · July 27, 2016, 06:46:16 AM

As usual wee digress...

especially when Jerry posts....

yes the extra e is intentional

Seldom Seen Slim · July 27, 2016, 07:05:33 AM

Stainless, I know it's an easy target, but since it's not Friday -- just relax and let it go. He can do a fine job all by himself.

floydjer · July 27, 2016, 07:40:04 AM

Quote from: Seldom Seen Slim on July 27, 2016, 07:05:33 AM
Stainless, I know it's an easy target, but since it's not Friday -- just relax and let it go. He can do a fine job all by himself.

single handedly..................

Ron Gibson · July 27, 2016, 07:49:58 AM

change hands without missing a ------?

Ron

floydjer · July 27, 2016, 08:11:29 AM

Eh-hem....

tauruck · July 27, 2016, 09:15:11 AM

Guys, without Jerry we get bored so just let him be!!.
Even if he's high as a kite.

Hey Jerry, got a nice email coming your way.
Hope you ain't afraid of lady dentists?.

tauruck · August 02, 2016, 04:58:35 AM

Front Stub Axles finally arrived.
They look good and are already in the deep freeze
for tomorrow's press fit and welding.

tauruck · August 02, 2016, 05:01:57 AM

Two more views of the parts, threaded ends are drilled for split pins.
I have NI98 welding rod and was thinking of using it for the EN8 and Rocktuff plate?.
What do you guys suggest?.

tauruck · August 04, 2016, 12:13:21 AM

I thought using the press was going to be a no brainer!!!!!.
I heated the uprights, had the spindles in the deep freeze for two days and couldn't get them to move.
I gave up and had a few Tequilas.

I'll be taking the parts over to my ex engineer Geraldo today. He'll have a solution or a bigger press.
This thing never ends.

tauruck · August 04, 2016, 06:49:30 AM

OD too big for the ID!.

Spindles need some minor machining.

I'll have them back tomorrow.
Not much going on except I have to find out what gauge wire I need for the different parts of the car.

manta22 · August 04, 2016, 08:43:10 AM

Quote from: tauruck on August 04, 2016, 06:49:30 AM
OD too big for the ID!.
Spindles need some minor machining.

I'll have them back tomorrow.
Not much going on except I have to find out what gauge wire I need for the different parts of the car.

Mike;

The wire size needed will depend on the length of the wire and how much current it handles. I can help you if you tell me those two things per wire.

Regards, Neil Tucson, AZ

News:

Springfield Flyer.